P781 Data Message; P799 Communications Control - Siemens Milltronics BW500 Operating Instructions Manual

11.3.10

P781 Data message

Note
Applicable only to ports programmed for printer communication (P770).
Sets the data message to be delivered via the selected port, ports 1 to 3 (P781-01 to -03). All
messages and printouts include time and date
Entry:
f
0 = no message
1 = rate
2 = total
3 = load
4 = speed
5 = rate, total
6 = rate and total
7 = batching
8 = rate and speed
9 = quick start parameters (P001 – P017)
10 = all parameters
Totalizer 1 and/or 2 as set by P647, Totalizer Display.
1)
Not available with BW500/L
2)
11.3.11

P799 Communications Control

Assigns programming control either locally through the keypad or Dolphin Plus (P770 = 1), or
remotely through Modbus protocol (P770 = 2 or 3) or SmartLinx.
Entry:
0 = local
1 = remote
When a SmartLinx card is installed and P799 = 1, the parameters that the SmarlLinx card is
writing to the BW500 and BW500/L will be continuously updated. Therefore, if you connect
a SmartLinx card to the BW500 and BW500/L, set P799 = 1 and not write anything to the
SmarLinx card, your setpoints will be zero.
BW500 and BW500/L
Operating Instructions, 12/2016, A5E33482052-AD
1)
, load and speed
1)
1)
2)
WARNING
11.3 Configuring Communication Ports
.
2)
Communications
131