Assembly Fault Identification And Replacement Sequence - Keysight N5264A Service Manual

Replaceable Parts

Assembly Fault Identification and Replacement Sequence

Assembly Fault Identification and Replacement Sequence
The following steps describe the procedure to identify, and then replace, a
faulty assembly.
Step 1. Identify the faulty group. Begin with
with the appropriate troubleshooting chapter that identifies the faulty
assembly.
Step 2. Order a replacement assembly. Refer to
chapter).
Step 3. Replace the faulty assembly and determine what adjustments are necessary.
Refer to
Step 4. Determine the necessary adjustments and performance tests to be
performed. Refer to
Step 5. Perform the necessary adjustments. Refer to
Adjustments."
Step 6. Perform the necessary performance tests. Refer to
Adjustments."
Step 7. Keysight personnel: see
calibration stickers should be placed on the PNA.
Keysight N5264A Service Guide
Chapter 7, "Repair and Replacement Procedures."
Table 7-2, "Related Service Procedures," on page
Figure 1-1 on page 1-6
Chapter 4, "Troubleshooting."
Chapter 6, "Replaceable Parts."
Chapter 3, "Tests and
Chapter 3, "Tests and
to review where the
Follow up
(this
42.
6-3