Keysight N5264A Service Manual page 126

Repair and Replacement Procedures
Removing and Replacing the A1–A3 and Other Front Panel Subassemblies
Figure 7-4 A3 Display Assembly and Touch Screen Removal-1
4. The display cable (item
5. The LCD display can be removed by disconnecting the LCD cable from the
Keysight N5264A Service Guide
To replace the touch screen, note the orientation of the rubber boot on the
old touch screen and then remove it and install it on the new one in the
same orientation.
⑦
(item ) that attach it to the LCD display hold down bracket (item
inverter board and then removing the four screws (item
the LCD display hold down bracket (item
⑩
spacers (item ) before separating the LCD display from the hold down
bracket.
⑥
) can be removed by removing the three screws
⑧
). Note the location of the four
⑧
).
⑨
) that attach it to
7-11