Keysight Measurement Receiver
PNA-X
Service Guide
3
Tests and Adjustments
Information in This Chapter
This chapter contains procedures to help you check, verify, and adjust your
PNA.
— The checks verify the operation of the assemblies in your analyzer.
— The verification compares the operation of your analyzer to a gold standard.
— The adjustments allow you to tune your analyzer for maximum response.
Conventions Used for Hardkeys, Softkeys, and Menu Items
The following conventions are used in this document:
Hardkey
Softkey
Menu Item
Chapter Three at-a-Glance
Section Title
Before You Begin
Performance Tests
Adjustments
This represents a "hardkey", a key that is physically located on the instrument.
This represents a "softkey", a key whose label is determined by the instrument
firmware.
This represents an item in a drop-down or pop-up menu.
Summary of Content
Items to consider or procedures to perform before testing is begun:
Verify the Operating Environment
—
Protect Against Electrostatic Discharge (ESD)
—
Allow the Analyzer to Warm Up
—
A brief summary of each performance test:
Frequency Accuracy Test
—
Setups and procedures for adjusting your analyzer:
10 MHz Frequency Reference Adjustment
—
EE Default Adjustment (Option 108)
—
3-1
Start Page
page 3-2
page 3-5
page 3-6