Fujitsu AUYG07LVLA Design & Technical Manual page 302

5) Again, referring to the Settings List shown below, press the SELECT button (SW932), and
display the code number of the function you want to set on the LED962.
Ex.) To select the Emergency Stop function
LED961 LED962
e t press the
set.
LED961 LED962
ashing disp a on the
This completes FUNCTION SETTING.
6) To exit FUNCTION SETTING, press the ENTER button (SW933) in the setting completed
status shown in step 5) above.
LED961 LED962
*2
seconds a ter e en i
automatically.
Then, press the MODE/EXIT button (SW931) to exit FUNCTION SETTING MODE.
LED961 LED962
7) To set another function, press the ENTER button (SW933) in the setting completed status
shown in step 5) above.
LED961 LED962
Repeat steps 4) and 5) above to set other functions.
When all settings are complete, perform the operation described in step 6) above to exit.
RESET THE POWER AFTER SETTING UP FUNCTION OF
OUTDOOR UNIT
Important
If the reset is not performed, function can not be read in normally.
After all the functions have been set, the circuit breaker needs to be switched off
for at least 2 minutes.
After the 2 minutes has passed, power can be restored.
The set function is stored in the PCB and will remain in memory even when the
power is turned off.
However setting function is effective after power reset.
Record the function set in the outdoor unit on a label, etc., and affix the label to the
unit so it can be used for after-sales service operations.
LED961 LED962
button and confir
LED961 LED962
changes to an i u inated disp a .
LED961 LED962
button is not pressed
LED961 LED962
LED961 LED962
- (06 - 54) -
the se ection o the unction ou want to
changes to a ashing disp a
6. SYSTEM DESIGN