Fujitsu AUYG07LVLA Design & Technical Manual page 306

5-3-1. AR-RAH2E / AR-RAH1E
SWITCHING SELECTION OF FUNCTION SETTING MODE
(2) Press and hold the "FAN" and the " SET TEMP.
press the "RESET" button.
SELECTION AND CONFIRMATION OF CUSTOM CODE
(3) Press the " SET TEMP.
TEMP. " buttons to select the signal code
q
that matches the setting with the indoor
unit. By selecting the appropriate signal
code, the communication between the
indoor unit and the wireless RC becomes
possible.
CUSTOM CODE
( - - - )
The initial setting is " "
FAN
SET TEMP. ( )
RESET
" or " SET
p
- (06 - 58) -
" buttons. While holding these 2 buttons,
p
Function setting
mode display
(4) Press the "TIMER MODE" button to send
the code to the indoor unit.
Pi Pi
6. SYSTEM DESIGN