4.2.2 PSU Modules
Note!
You need:
-
No special tools
-
A spare PSU module
To replace a PSU module, proceed as follows:
1.
Locate the PSU module to be replaced (failing / degraded)
2.
Remove the power cord from the PSU power connector PS3
3.
Grab the PSU handle PS2 and unlock the PSU module by pulling the PSU lock
PS4 to the left
4.
Hold the lock and extract the PSU module towards you.
Insert a new PSU module into the bay. Make sure the module is fully seated. The
5.
lock will flip to the right automatically when the module is seated.
6.
Connect the power cord.
7. The PSU module should start operation and the PSU Status LED PS6 should turn
blue.
You may want to check the PSU status via Advanced Platform Management and
8.
also clean the System Event Log.
SKY-8100 Manual V05 20161229
Figure 4-30: PSU Modules
Copyright 2016 Advantech Co. Ltd. All rights reserved.
Page 102