Disk Drives; Hdd; Msata Ssd; Figure 4-31: 2.5" Hdd - Advantech sky-8100 User Manual

4.2.3 Disk Drives

4.2.3.1 2.5" HDD

Note!
You need:
- A PH2 screw driver
- A standard 2.5" HDD/SSD
To remove the HDD, proceed in the reverse of the installation procedure in
4.1.2.
1. Open the front cover.
Unlock the tray by moving the orange lock to the left. Push the tray's black button
2.
to open the tray handle.
3. Grab the tray handle and pull it evenly towards you.
Remove the 2.5" drive mounting screws.
4.
5. Install a new HDD by following the instructions in

4.2.3.2 mSATA SSD

Note!
You need:
- A PH1 screw driver
- A standard M.2 SSD
- Power down the unit
To remove a M.2 SSD proceed in the reverse of the installation procedure as below:
1. Remove the top cover and PCIe card cage CG2
2. Locate the M.2 SSD to be replaced (M1 or M2)
3. Remove the M.2 mounting screws. Please be sure to hold the last screw as the
spring mechanism in the M.2 connector will flip the M.2 module upwards once the
screw is lose.
4. Extract the M.2 module
Also refer to Section
SKY-8100 Manual V05 20161229

Figure 4-31: 2.5" HDD

4.1.4.2.
Copyright 2016 Advantech Co. Ltd. All rights reserved.
Section 4.1.2.
Section
Page 103