Remove The Chassis (Inner) Member; Mount The Chassis (Inner) Member To The Chassis; Figure 4-2: Remove The Inner Chassis; Figure 4-3: Mount The Inner Chassis - Advantech sky-8100 User Manual

4.1.1.1 Remove the Chassis (Inner) Member

Pull the slide open. Then press the trigger down as shown on the drawing, and pull the
chassis (inner) member out.
Note!
Extendable front bracket only apply to some Tool-less mode.

4.1.1.2 Mount the Chassis (Inner) Member to the Chassis

You many opt for M4 or M5 pan head screw. The screw head of either M4 or M5 can
not exceed 2.0mm. Alternatively, you may mount the slider member to the chassis
through standoffs. Likewise, the head of stand-off can not exceed 2.0mm. Each side of
chassis is highly suggested to use 3 of screws or standoffs for slide attachment.
SKY-8100 Manual V05 20161229

Figure 4-2: Remove the Inner Chassis

Figure 4-3: Mount the Inner Chassis

Copyright 2016 Advantech Co. Ltd. All rights reserved. Page 88