3.3.3 BIOS
Use the following command to perform a BIOS upgrade:
#ipmitool –I lanplus –H <BMC IP> -U administrator –P advantech hpm
upgrade <BIOS image> -z 1500
#ipmitool –I lanplus –H <BMC IP> -U administrator –P advantech hpm
activate
BIOS upgrade requires a reset of the x86 host to take effect. Use the command below
to reboot the system:
#ipmitool –I lanplus –H <BMC IP> -U administrator –P advantech chassis
power cycle
After the system reboot is completed, users may check if the active BIOS version is
consistent with the upgraded BIOS version:
#ipmitool –I lanplus –H <BMC IP> -U administrator –P advantech hpm
check
SKY-8100 Manual V05 20161229
Figure 3-11: BIOS Upgrade
Copyright 2016 Advantech Co. Ltd. All rights reserved.
Page 83