Rtc Battery; Figure 4-32: Unlocking The Battery - Advantech sky-8100 User Manual

1u carrier grade server based on processor intel xeon-d series

Table of Contents

4.2.4 RTC Battery

Note!

You need:

A BR2032 battery

Power down the unit

Warning!

There is the danger of explosion if the battery is replaced incorrectly.

Replace the battery only with the same or equivalent type specified

above.

Dispose of used batteries according to the manufacturer's instructions.

To replace the RTC's battery located at B1 proceed as follows:

1. Remove the left PCIe card cage CG2 as described in

2. Pull the spring clip securing the battery to the side with your finger tip as shown

below. Then extract the battery.

Keeping the spring clip pulled towards you, insert the replacement battery.

Caution!

Please make sure you insert the battery in correct polarity with the positive

pole up.

4. Trying to insert the battery with incorrect orientation/polarity will damage the battery

holder. Additional security risks apply as stated above.

5. When the coin cell is seated release the spring clip and control that it moves back

into its original position and that it secures the battery correctly.

6. Reinstall the PCIe card cage and the top cover.

SKY-8100 Manual V05 20161229

Section

4.1.3.

Page 104

Table of Contents