Notifier AFP-300 Installation Manual page 78

 ,QVWDOODWLRQ
1RWH 6FUDSH SDLQW DZD\ IURP
WKH FDELQHW WR PDNH JRRG
HOHFWULFDO FRQQHFWLRQV
1RWH 7KH VKLHOG GUDLQ ZLUH
PXVW EH FRQQHFWHG WR WKH
QHJDWLYH ² VLGH RI WKH ORRS
'R QRW OHW WKH VKLHOG GUDLQ
ZLUH RU WKH VKLHOG IRLO WR
WRXFK WKH V\VWHP FDELQHW
1RWH ,I WKH OHQJWK RI FRQGXLW IURP WKH
FRQWURO SDQHO FDELQHW H[FHHGV  IHHW
WHUPLQDWH WKH VKLHOG DV VKRZQ ,I XVLQJ D
PHWDO ER[ \RX PXVW XVH D PHWDO FRQGXLW
2-42
www.PDF-Zoo.com
6/&6KLHOG7HUPLQDWLRQ
All wiring leaving the control panel must be shielded. Figure 2-56, Figure
2YHUYLHZ
2-57, and Figure 2-58 show three methods of wiring termination, depending on the type
of conduit used: a) no-conduit, b) full-conduit, and c) partial-conduit.
1R&RQGXLW 6KLHOG 7HUPLQDWLRQ
system cabinet. Connect the drain wire to the outside of the cabinet using a cable
connectors as shown in Figure 2-56:
6KLHOG 'UDLQ :LUH
)LJXUH  6KLHOG 7HUPLQDWLRQ ² 1R &RQGXLW
)XOO&RQGXLW 6KLHOG 7HUPLQDWLRQ
connect each end of the shield to the negative side of the respective channel as shown in
Figure 2-57:
)LJXUH  6KLHOG 7HUPLQDWLRQ ² )XOO &RQGXLW
3DUWLDO&RQGXLW 6KLHOG 7HUPLQDWLRQ
system cabinet or the conduit. Connect the drain wire to the termination point of the
conduit run.
)LJXUH  6KLHOG 7HUPLQDWLRQ ² 3DUWLDO &RQGXLW
Wiring a Signaling Line Circuit (SLC)
Do not allow the shield drain wire to enter the
For Style 6 or Style 7 field-wiring of the SLC,
&DELQHW
Do not allow the shield drain wire to enter the
6KLHOG 'UDLQ :LUH
AFP-300/AFP-400 Installation PN 50253:C1 05/22/97
&DELQHW
6/& 
6/& ²
6KLHOG 'UDLQ :LUH 7KH
VKLHOG PXVW QRW EH FRQQHFWHG
WR HDUWK JURXQG DW DQ\ SRLQW
6/& 
6/& ²
&DELQHW
6/& 
6/& ²