Notifier AFP-300 Installation Manual page 152

 $SSOLFDWLRQV
2YHUYLHZ
&$%; ,QVWDOODWLRQ
0RGXOH
,QVHUWLQJ Q\ORQ VWDQGRII DQG
VHOIWDSSLQJ VFUHZ
&$%$$ ,QVWDOODWLRQ
0RGXOH
,QVHUWLQJ Q\ORQ VWDQGRII
DQG VHOIWDSSLQJ VFUHZ
5-14
www.PDF-Zoo.com
,QVWDOOLQJWKH8=&
You can mount the UZC-256 into a CAB-X3 or a CAB-400AA. This section shows
how to install the UZC-256 both ways. For information on configuring the UZC-256
module, refer to Section 5, "Applications."
The UZC-256 mounts beneath the third and fourth modules on the CHS-4 chassis, to
the right of the CPU. Install the module as follows:
1. Thread the supplied three hex standoffs to the mounting studs on the CHS-4
chassis (Figure 2-13).
&+6
0RXQWLQJ VFUHZV WKUHH SODFHV
+H[ VWDQGRII WKUHH SODFHV
)LJXUH  0RXQWLQJ D 8=& WR D &+6
2. Place the module onto the CHS-4 as shown in Figure 2-13; then, insert and tighten
the mounting screws.
You can also mount the module to the upper right corner of the CAB-400AA Series
cabinet as follows:
1. Place the module into the CAB-400AA as shown in Figure 2-14.
&$%$$ &DELQHW
8=& 0RGXOH
&$%$$
6HOIWDSSLQJ VFUHZ
WKUHH SODFHV
)LJXUH  0RXQWLQJ WKH 8=& LQWR D &$%$$ &DELQHW
2. Attach the module to the CAB-400AA with the self-tapping screws.
Universal Zone Coder (UZC-256)
&+6 &KDVVLV
8=& 0RGXOH
AFP-300/AFP-400 Installation PN 50253:C1 05/22/97