Notifier AFP-300 Installation Manual page 131

Wiring Speaker Circuits
:LULQJ 1RWHV
:LULQJ 'LDJUDP
5HVLVWRUV 5 DQG 5 RQ WKH
$$
AFP-300/AFP-400 Installation PN 50253:C1 05/22/97
www.PDF-Zoo.com
:DWW(LJKW6SHDNHU&LUFXLW&RQILJXUDWLRQ
When wiring eight speaker circuits using 180 watts of power, note the following:
1. AA-30 audio power is drawn from plug P6 or terminals 6 and 7 of terminal block
P8. This audio power run is not supervised. If using the optional supervised return
(plug P7 or terminals 2 and 3 of block P8), a loss of audio power due to a break in
the wiring will generate a trouble signal at the AA-30.
2. If using an optional supervised four-wire return, cut resistors R8 and R9 (for the
location of R8 and R9, see Figure 4-37).
3. Each circuit can handle a maximum of 30 watts.
4. In this configuration, cut VCE-4 and VCM-4 jumpers JP1 and JP2.
Figure 4-37 shows typical wiring for a 180-watt, eight-speaker circuit:
 ZDWWV
WZR FLUFXLWV
$XGLR 2XWSXW &DEOH
31 
)LJXUH  7\SLFDO :DWW (LJKW6SHDNHU &LUFXLW
 ZDWWV  ZDWWV ² 7KHVH IRXU FLUFXLWV
WZR FLUFXLWV FDQ KDQGOH  ZDWWV HDFK
 9RLFH $ODUP 6\VWHP
$XGLR 2XWSXW &DEOH
31 
4-31