Notifier AFP-300 Installation Manual page 103

Installing an AMG
$0*( ,QWHUFRQQHFW &DEOH
(,$ &RQQHFWLRQV
AFP-300/AFP-400 Installation PN 50253:C1 05/22/97
www.PDF-Zoo.com
Figure 4-2 shows the AMG-1 terminals:
7URXEOH ,QSXW &DEOH
3RZHU +DUQHVV 2XW
3RZHU +DUQHVV ,Q
Table 4-2 contains descriptions of the AMG-1 terminals:
Input/Output
Trouble Input Cable
(normally open trouble
contacts) PN 75098
Trouble Output Cable
(normally open trouble
contacts) PN 71033
Power Harness Out
PN 75099
Power Harness In
PN 75396 or 75100
AMG-1 Interconnect
Cable PN 75136
EIA-485 Connections
No connection
Audio Signal Connections
PN 75110
Control Harness
PN 75097
Low Level Audio
PN 75100
3 3
)LJXUH  $0* 7HUPLQDOV
Plug Used to...
P9 Transmit trouble signals to another system device. (Connect the
other end to the Trouble Input of the other device in the system or
to J4 (Aux Trouble Input) on the MPS-400.)
P8 Transmit trouble signals to another device in the system.
P2 Connect to another power supply in a power supply chain.
P1 Provides power for the AMG-1 from the Main Power Supply.
(Connect the other end to J1 on the MPS-400.)
P10 Connect from the Trouble Output contacts on another AMG-1.
A closure signals the AMG-1 that the connected device is in
trouble.
P3 Lets the control panel communicate with the AMG-1 through the
ACS mode EIA-485 port.
P7 N/A
P5 Allow harnessing the audio signal from the AMG-1 to Audio
Amplifiers in the same cabinet via P5, or wired to amplifiers in
remote cabinets through P4.
P6 Connect to P4 on a Fire Fighter's Telephone (FFT-7) or cable
from the Audio Voice Link (AVL-1).
P4 Allows wiring of the AMG audio output to an Audio Amplifier
as follows:
Connector
Low Level Audio Output to first
amplifier
Low Level Audio Output
Return to last amplifier (optional)
Table 4-2 AMG-1 Terminal Connections
 9RLFH $ODUP 6\VWHP
7URXEOH 2XWSXW &DEOH
1R &RQQHFWLRQ
&RQWURO +DUQHVV
$XGLR 6LJQDO LQWHUQDO
$XGLR 6LJQDO
3
H[WHUQDO
From To
AMG... AA...
P4-5 P3-5
P4-4 P3-4
P4-2 P3-2
P4-1 P3-1
4-3