ACT-1 Audio Coupling Transformer
,QVWDOODWLRQ 1RWHV
,QVWDOODWLRQ 'LDJUDP
&RQQHFWLQJ WKH $&7
AFP-300/AFP-400 Installation PN 50253:C1 05/22/97
www.PDF-Zoo.com
$&7,QVWDOODWLRQ
The ACT-1 connects to one of up to eight amplifiers on a channel. Multiple ACT-1s
are required for amplifiers on multiple channels.
To install an ACT-1, follow these steps:
1.
Connect the low-level audio circuit to the terminal block on the ACT-1.
2.
Connect the ACT-1 to the first amplifier in the chain.
Figure 4-43 shows ACT-1 connections:
3
$0*
$0* 3RODULW\
3
$7*
3
$7* /RZ
OHYHO 2XWSXW
)LJXUH $&7 &RQQHFWLRQV
Connect an ACT-1 as follows:
Step
Action
1
Using the supplied cable, connect the Earth ground terminal on each ACT-1 to P8 on the AA-100/
AA-120 or to a screw on the upper left corner of the AA-30. The COMN terminal is intended for
optional shielding of the secondary side of the ACT-1 (low-level audio from the ACT-1 through
each amplifier). To use shield, connect to the common of the local power supply—but do not
connect this shield to the shield from the primary side of the ACT-1.
2
Daisy-chain the secondary side of the ACT-1 (low-level audio) up to a maximum of eight
amplifiers.
3
Draw additional low level audio risers (isolated from the main riser) from P4 on an audio amplifier.
7DEOH &RQQHFWLQJ DQ $&7
7HUPLQDO 'HVLJQDWLRQ RQ WKH $&7
7%
²
2XW
$XGLR 2XW
5HWXUQ
²
DPSOLILHUV
$7* /RZOHYHO
LQ IURP $0* RU $7*
6KLHOG 2XW WKUX
2XW
2XW ²
,Q
,Q ²
(YDF
(YDF ²
$OHUW
$OHUW ²
9RLFH $ODUP 6\VWHP
3
6
²
6KLHOG ,Q
33
$$$$
4-37