Alternate Method For Programming Zone Descriptors - ADEMCO 5110XM Installation Instructions Manual

Alternate Method For Programming Zone Descriptors

W h e n e n t e r i n g
Descriptors using Method
2, the keypad keys perform
the following functions:
[3] Scrolls both alphabet and
actual words in ascending
alphabetical order.
[1] Scrolls both alphabet and
actual words in descending
alphabetical order.
[6] Selects between alphabet
and actual word list; also
used to save words.
[8] Stores the zone descrip-
tion in memory.
S
ZN 0 1
DO O R
Flashing Cursor if "6" is
pressed (system ready for
next word).
Summary Display
S
ZN 0 1
DO O R
P r o g r a m A lph a ?
0 = No , 1 = Ye s
A lph a P g m
1. Perform steps 1 through 5 of previous method.
Z o n e
2. Note that the first letter of the alphabet appears after the zone number,
and that the zone number is automatically included with the description. If
there already is a description for the zone , the description will appear (with
no cursor, since this is a display mode). To enter or change a description ,
press [ ] + Zone Number again. A flashing cursor will now appear.
*
Assume, for example, that the desired description for zone 1 is BACK
DOOR.
3. Select the first letter of the desired description (note that "A" is
already displayed).
Press key [3] repeatedly to advance through the alphabet (e.g., to "B"), or
key [1] to go backward. Then press [6] to display the first available word
beginning with the desired letter (e.g., BABY).
Next, press [3] repeatedly to move forward, or [1] to move backward, until
the desired word is displayed (e.g., BACK). Then press [6] to accept the
word and toggle back to the alphabet list.
9. Press "6" to accept the selected
BA CK
A
+
10. The two words in our example have
BA CK
11. To enter a descriptor for the next zone,
12. To exit the Alpha descriptor mode,
0 0
13.
8 2
14. Press
– 36 –
word.
Note: If these are the only words you
are using for the descriptor, press " 8"
instead of "6" to save them in memory.
now been entered. Note, however, that
up to three words may be entered
(provided the number of characters will
fit on the screen). Press "8" to save
all words in memory.
The "A" with the flashing cursor over it
will disappear, indicating that the
word(s) are stored in memory for that
zone, as shown in the summary display
at the left.
press plus the desired zone number
*
(e.g., 02. The summary display
*
following step 4 previously will appear.
Now repeat steps 5 through 10 for the
descriptor for the next zone.
press " 0+0" at the summary display.
*+
This prompt will be displayed.
Press "0". This will be displayed.
99 to exit the programming
*
mode.