Section 2. Installing The Control; Getting The Control Up And Running; Mounting The Cabinet; Installing The Lock - ADEMCO 5110XM Installation Instructions Manual

Section 2. INSTALLING THE CONTROL

This section provides instructions for getting the system up and running quickly, as well as
detailed instructions for the following:

• Getting the control up and running

• Installing the cabinet lock
• Mounting the control cabinet
• Installing the main PC board
• Standard phone line connections
• Installing the back-up battery in the cabinet
• Connecting the AC transformer
• Making earth ground connections
Getting the Control Up and Running
The following procedure is recommended for getting the 5110XM up and
running quckly. Refer to each individual section (as indicated in parenthesis)
for a more detailed overview of each step:
1. Mount the cabinet, pc board and lock (*see the paragraphs following this
procedure for details on Mounting the Cabinet, and Installing the Lock)
2. Unpack the LED indicator pc board and plug it into the J5 header on the
5110XM PC board.
3. Wire the telephone lines, AC transformer, earth ground, optional remote
keypads (if used), zones and supplementary alarm sounders (if used). (refer
to the appropriate sections as required)
4. Program the control's telephone numbers and subscriber account numbers.
Select the desired report format and program the desired report codes.
Refer to the section on System Communications for more information on
related programming. A 6139 or 6139R must be used to program the
5110XM locally.
5. Revise the default program selection as required.
Refer to the sections on Mechanics of Programming and Data Field
Descriptors and the Program Form for details on the various programming
options.
6. If a remote keypad is to be permanently installed, program a user 2 code for
the system's principle user. The Master Code as programmed in field *20
is meant for the installer's use only and must not be given to the system's
user.
Refer to the section on System Operation for details on entering user codes.
7. Test the system to verify proper operation (refer to the section on TESTING
THE SYSTEM ).

Mounting the Cabinet

Mount the control cabinet to a sturdy wall using fasteners or anchors (not
supplied), in a clean, dry area which is not readily accessible to the general
public. Four mounting holes are provided at the back of the cabinet. When
used as a slave DACT for a listed FACP, it is recommended (but not required)
that the 5110XM be mounted near the FACP.

Installing the Lock

Use an Ademco No. N6277 Cam Lock and No. N6277–1 Retainer Clip
(supplied).
– 9–