Testing The Sounder - ADEMCO 5110XM Installation Instructions Manual

7. Press *86 (Zones 10-12, 95, and 96 Bell / Aux. Relay Activation)
0
Enter [0] for NO ALARM ACTIVATION (* always enter [0] in the first
space), [1] for BELL only, [2] for AUX. RELAY only, or [3] for BELL &
AUX. RELAY. (default = [0] [0] [0] [0] [0] [0])
NOTE: Zones programmed for fire alarm response (zone types 09, 16, or 17)
MUST be programmed to activate the bell output (can trigger the aux relay
additionally). Therefore, option 1 or 3 must be selected for fire zones.
8. Use *56 to program system zone 6 as required.
9. Exit the programming mode by entering

Testing the Sounder

After installation of the sounder is completed, the control should be carefully
tested, as follows.
1. Apply AC power and connect the backup battery to the control's PC board.
2. Verify that all hard-wired zones are intact and that there are no system trouble
conditions present. The keypads should displ;ay "system normal" (alpha) or
"AC" (fixed word).
3. Perform the FIRE DRILL TEST:
This test activates the optional external alarm sounders, wired to the bell
output on terminals 3 and 4, in a pulsing* (or steady) manner, whichever was
programmed in field *77. This test may be performed only on systems that
have an optional remote keypad and external fire alarm sounders installed.
This test may be initiated with the master code or the user #2 code only (when
no alarm, supervisory, or trouble conditions are present). The system remains
operational for alarm signaling while this test is active.
* Pulsing causes the bell to sound in the NFPA 3 pulse temporal pattern.
To initiate the FIRE DRILL test enter the master code (or the user # 2 code)
+ [#] [6] [9] on any remote keypad. The following will be displayed on an
alpha keypad:
To exit this test enter ANY user code + OFF.
Fi re Dri l l A c ti ve
* or [TEST dF] on fixed-word keypads
– 26 –
99.
*