ADEMCO 5110XM Installation Instructions Manual page 50

DIALER
PROGRAMMING
( 40– 50)
* *
Fields 40, 41, 42:
* * *
Enter up to the number of
digits shown. Do not fill
unused spaces.
Enter 0–9,
# + 11 for " *"
# + 12 for "#'"
# + 13 for a pause
(2.5 secs)
*31
AUXILIARY RELAY TIMEOUT
This field determines whether the auxiliary relay will shut off after
time allotted, or continue until manually turned off. Enter as follows:
0 = No timeout; 1 = 4 min.; 2 = 8 min.; 3 = 12 min.; 4 = 16 min. (default)
*32
SUPERVISORY ON OPEN/SHORT
If enabled (enter a [1]) this field provides a supervisory condition on
BOTH an open or short circuit.
Trouble condition, and a short will cause a Supervisory condition.
(default = 0)
*33 BACKUP DIALER PULSE/TONE
Enter [1] for Touch Tone or [0] for Pulse Dial (default = 0)
*34 AUXILIARY RELAY FUNCTION
This field determines how the on-board auxiliary relay will be used.
[0] = activate on Trouble/Supervisory, [1] = activate on Alarm, silenced
by pressing the silence/reset button, or code + off (if remote keypad is
used), [2] = Smoke Detector Reset, [3] = Battery Saver Option, [4] =
activate on Alarm, silenced by code + #67 (only if a remote keypad is
used)
Note: When function 1 or 4 is selected, program fields *85 and *86 to
select zones which will trigger aux. relay. When function 1 is selected,
program aux. relay timeout in field *31.
40 PABX ACCESS CODE (See Box at Left)
*
Enter up to 4 digits if PABX is needed to access an outside line. If
fewer than 4 digits are needed to be entered, exit by pressing
next field number (e.g., 41). To clear entries from field, press
* 41 PRIMARY PHONE No.
| | | | | | | | | | |
If fewer than 12 digits entered, exit by pressing
number (e.g., 42). To clear entries from field, press
42 SECONDARY PHONE No.
*
| | | | | | | | | | |
Enter up to 12 digits.
If fewer than 12 digits entered, exit by pressing
number (e.g., 43). To clear entries from field, press
43 SUBSCRIBER ACCOUNT. No
*
(Enter 3 or 4 digits).
Enter digits 0–9; #+11 = B; # +12 = C; # +13 = D; #+14 = E; or #
+15 = F.
To clear entries from field, press
See blank Programming Form for examples of Account No.
entries.
If only 3-digits are needed exit by pressing * after the 3rd digit
plus the next field number (e.g., 45).
45 MAIN DIALER PULSE/TONE
*
Enter [1] for Touch Tone or [0] for Pulse Dial (default = 0)
–50–
If disabled, [0], an open will cause a
Enter up to 12 digits.
and next field
*
*
and next field
*
*
43
* *
| | |
and
*
40 .
* *
41
*
42
*
| | |