Checking The Rubber Grip; Adjusting The Basic Position Of The Clutch Lever - Husqvarna TC 125 2017 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.43

Checking the rubber grip

11.44

Adjusting the basic position of the clutch lever

(TC 250, TX 300)
–
Check the throttle cable routing.
The throttle cable must be routed along the back of the handlebar, to the
right of the frame, above the fuel tank bracket, and to the carburetor. The
throttle cable must be fixed on the fuel tank bracket with a rubber band.
» If the throttle cable is not routed as specified:
–
H01552-10
Finishing work
–
Install the fuel tank.
–
Install the right side cover. (
–
Mount the seat. (
–
Install the air filter box cover. (
–
Check the rubber grips on the handlebar for damage, wear, and looseness.
Info
The rubber grips are vulcanized onto a sleeve on the left and onto the han-
dle tube of the throttle grip on the right. The left sleeve is clamped onto the
handlebar.
The rubber grip can only be replaced with the sleeve or the throttle tube.
» If a rubber grip is damaged or worn
–
Change the rubber grip.
401197-01
–
Check that screw
Guideline
Screw, fixed grip
Diamond
M01455-10
–
Adjust the basic position of the clutch lever to your hand size by turning adjusting

screw
Info
When the adjusting screw is turned counterclockwise, the clutch lever
moves away from the handlebar.
When the adjusting screw is turned clockwise, the clutch lever moves
closer to the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply any force.
H01557-10
Do not make any adjustments while riding.
Correct the throttle cable routing.
( p. 63)
p. 61)
p. 54)
p. 56)

is firmly seated.
M4

must be located at the top.
.
5 Nm Loctite ® 243™
(3.7 lbf ft)
69