Changing The Ignition Timing Map; Checking The Basic Position Of The Shift Lever; Adjusting The Basic Position Of The Shift Lever - Husqvarna TC 125 2017 Owner's Manual

16 TUNING THE ENGINE
16.8

Changing the ignition timing map

Switch the ignition timing map from Performance to Soft
(All TC models)
–
Disconnect plug-in connector
Soft – better rideability
(TX 300)
–
Disconnect plug-in connector
Soft – better rideability
Switch the ignition timing map from Soft to Performance
(All TC models)
–
Join plug-in connector
Performance – better performance
(TX 300)
–
Join plug-in connector
Performance – better performance
16.9

Checking the basic position of the shift lever

Info
When driving, the shift lever must not touch the rider's boot when in the basic position.
When the shift lever keeps touching the boot, the transmission will be subject to an excessive load.
16.10

Adjusting the basic position of the shift lever


of the ignition timing map adjustment. (Figure S01279-10

of the ignition timing map adjustment. (Figure S01280-10

of the ignition timing map adjustment. (Figure S01279-10

of the ignition timing map adjustment. (Figure S01280-10
–
Sit on the vehicle in the riding position and determine distance
upper edge of your boot and the shift lever.
Distance between shift lever and
upper edge of boot
» If the distance does not meet specifications:
–
Adjust the basic position of the shift lever.
400692-10
–
Remove screw
401950-12
–
Clean gear teeth
–
Mount the shift lever on the shift shaft in the required position and engage the
gearing.
Info
The range of adjustment is limited.
The shift lever must not come into contact with any other vehicle compo-
nents during the shift procedure.
–
Locate and tighten screw
401951-10
Guideline
Screw, shift lever

with washers and take off shift lever

of the shift lever and shift shaft.

with washers.
M6
p. 101)
p. 101)
p. 101)
p. 101)

between the
10... 20 mm (0.39... 0.79 in)
( p. 102)

.
Loctite
14 Nm
(10.3 lbf ft)
102
® 243™