12 SERVICE WORK ON THE CHASSIS
12.28
12.29
64
S01043-10
Checking the rubber grip
401197-01
W00116-10
Checking/correcting the fluid level of the hydraulic clutch
Warning
Skin irritation Brake fluid causes skin irritation.
–
Keep brake fluid out of the reach of children.
–
Wear suitable protective clothing and safety glasses.
–
Do not allow brake fluid to come into contact with the skin, the eyes or clothing.
–
Consult a doctor immediately if brake fluid has been swallowed.
–
Rinse the affected area with plenty of water in the event of contact with the skin.
–
Rinse eyes thoroughly with water immediately and consult a doctor if brake fluid comes into contact
with the eyes.
–
If brake fluid spills on to your clothing, change the clothing.
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
–
Adjust the basic position of the clutch lever to your hand size
by turning adjusting screw
–
When adjusting the clutch lever, make sure to leave a mini-
mum clearance to other parts of the vehicle.
Guideline
Minimum clearance
–
Check the rubber grips on the handlebar for damage, wear,
and looseness.
Info
The rubber grips are vulcanized onto a sleeve on the
left and onto the handle tube of the throttle grip on the
right. The left sleeve is clamped onto the handlebar.
The rubber grip can only be replaced with the sleeve
or the throttle tube.
»
If a rubber grip is damaged or worn:
–
Change the rubber grip.
–
1
Check that screw
is firmly seated.
Guideline
Screw, fixed
M4
grip
A
Diamond
must be located at the top.
1
.
5 mm (0.2 in)
5 Nm (3.7 lbf ft)
®
Loctite
243™