Handlebar Position; Adjusting The Handlebar Position - Husqvarna TC 125 2017 Owner's Manual

10 TUNING THE CHASSIS
10.16

Handlebar position

10.17

Adjusting the handlebar position

Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a result.
–
Change the handlebar if the handlebar is damaged or bent.
Info
Turn clockwise to increase damping; turn counterclockwise to reduce
damping.
–
Mount protection cap
The holes on the handlebar supports are placed at a distance of
Hole distance A
The handlebar can be mounted in 2 different positions. In this way, the handlebar can
be mounted in the most comfortable position for the rider.
H01188-10
Preparatory work
–
Remove the handlebar cushion.
Main work
–
Remove screws
lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
–
Position rubber bushings
–
Place the handlebar supports in the required position.
Info
The handlebar supports are longer and higher on one side.
Position the left and right handlebar supports evenly.
–
Mount and tighten screws
Guideline
Screw, handlebar support
H01189-10
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamp.
–
Mount screws
–
First bolt the handlebar clamp with screws
handlebar supports so that both parts touch.
–
Tighten screws
Guideline
Screw, handlebar clamp

.
3.5 mm (0.138 in)

. Take off the handlebar clamp. Remove the handlebar and

. Take off handlebar supports

and push through nuts

.
M10

but do not tighten yet.

evenly.

from the center.

.

from below.
40 Nm Loctite
(29.5 lbf ft)

onto the longer, higher side of the
M8 20 Nm (14.8 lbf ft)
41
® 243™