Table of Contents
Advertisement
16
TUNING THE ENGINE
16.1
Checking the play in the throttle cable
16.2
Adjusting the play in the throttle cable
–
Check the throttle grip for smooth operation.
–
Move the handlebar to the straight-ahead position. Move the throttle grip back
and forth slightly to determine the play in throttle cable
Play in throttle cable
»
If the throttle cable play does not meet specifications:
–
Adjust the play in the throttle cable.
Danger
400192-11
Danger of poisoning Exhaust gases are toxic and inhaling them may
result in unconsciousness and death.
–
–
–
Start the engine and let it run idle. Move the handlebar to and fro over the entire
steering range.
The idle speed must not change.
»
If the idle speed changes:
–
Adjust the play in the throttle cable.
Preparatory work
(All TC models)
–
Turn handle
(Figure F00230-10
(TX 300)
–
Turn handle
(Figure F00231-10
–
Remove the air filter box cover. (
–
Remove the seat. (
–
Remove the right side cover. (
–
Remove the fuel tank.
–
Check the throttle cable routing. (
Main work
–
Move the handlebar to the straight-ahead position.
–
Push back sleeve
–
Ensure that the throttle cable sleeve is pushed all the way into barrel adjuster
–
Loosen nut
S01285-10
–
Turn adjusting screw
tle grip.
Guideline
Play in throttle cable
–
Tighten nut
–
Slide on sleeve
400192-11
Finishing work
–
Check the throttle grip for smooth operation.
–
Install the fuel tank.
–
Install the right side cover. (
Always make sure there is sufficient ventilation when running the
engine.
Use an effective exhaust extraction system when starting or running
the engine in an enclosed space.
of the fuel tap to the OFF position.
p. 16)
of the fuel tap to the OFF position.
p. 16)
p. 55)
p. 53)
p. 60)
(
p. 61)
p. 68)
.
.
in such a way there is throttle cable play
.
.
(
p. 63)
p. 61)
.
2... 3 mm (0.08... 0.12 in)
(
p. 96)
(
p. 96)
2... 3 mm (0.08... 0.12 in)
96
.
in the throt-
- Quick Links:
- Changing the Gear Oil
Hide quick links:
Advertisement
Table of Contents
