Preparing For Rides On Wet Sand - Husqvarna TC 125 2017 Owner's Manual

7 PREPARING FOR USE
7.5

Preparing for rides on wet sand

–
Check the radiator cap.
Value on the radiator cap
» If the indicated value does not correspond to the required value:
M01129-01
–
Change the radiator cap.
–
Fit a waterproofing device on the air filter.
Waterproofing device for air filter (79006921000)
Info
Observe the fitting instructions for Husqvarna Motorcycles accessories.
M01274-01
–
Adjust the carburetor jetting and setting.
Info
The recommended carburetor tuning is available from your authorized
Husqvarna Motorcycles workshop.
M01107-01
–
Clean the chain.
–
Fit the steel sprocket.
Tip
Do not grease the chain.
–
Clean the radiator fins.
–
Straighten bent radiator fins carefully.
Condition
600868-01
Regular use in sand
–
Change the piston every 10 operating hours.
Warning
Danger of scalding During motorcycle operation, the coolant
gets very hot and is under pressure.
–
Do not open the radiator, the radiator hoses or other cooling
system components if the engine or the cooling system are at
operating temperature.
–
Allow the cooling system and the engine to cool down before
you open the radiator, the radiator hoses or other components
of the cooling system.
–
In the event of scalding, rinse the area affected immediately
with lukewarm water.
1.8 bar (26 psi)
23