11
SERVICE WORK ON THE CHASSIS
11.8
Installing the fork protector
11.9
Removing the lower triple clamp
–
Position the fork protector on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the brake line and clamp. Mount and tighten screws
–
Position the fork protector on the right fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
F00047-11
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove the start number plate. (
–
Remove the front fender. (
–
Remove the handlebar cushion.
Main work
–
Take off cable holder
–
Remove screw
–
Remove screw
–
Take off the upper triple clamp with the handlebar and set it aside.
Info
Protect the components against damage by covering them.
Do not bend the cables and lines.
F00236-10
–
Remove O-ring
–
Take off the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
H01528-10
p. 43)
(
p. 81)
(
p. 44)
p. 50)
p. 50)
in front of the left radiator.
.
.
. Remove protective ring
M6
10 Nm (7.4 lbf ft)
.
M6
10 Nm (7.4 lbf ft)
.
46
.
.