11
SERVICE WORK ON THE CHASSIS
–
Check the chain sliding guard for wear.
»
If the lower edge of the chain pins is in line with or below the chain sliding
guard:
–
Change the chain sliding guard.
–
Check that the chain sliding guard is firmly seated.
»
If the chain sliding guard is loose:
–
Tighten the screws on the chain sliding guard.
Guideline
Screw, chain sliding
guard
H01555-10
–
Check the chain sliding piece for wear.
»
If the lower edge of the chain pins is in line with or below the chain sliding
piece:
–
Change the chain sliding piece.
–
Check that the chain sliding piece is firmly seated.
»
If the chain sliding piece is loose:
–
Tighten the screw on the chain sliding piece.
Guideline
Screw, chain sliding piece
H01556-10
–
Check the chain guide for wear.
Info
Wear can be seen on the front of the chain guide.
»
If the light part of the chain guide is worn:
–
Change the chain guide.
401760-01
–
Check that the chain guide is firmly seated.
»
If the chain guide is loose:
–
Tighten the fitting on the chain guide.
Guideline
Remaining screws, chassis
Remaining nuts, chassis
M01368-01
Finishing work
–
Remove the motorcycle from the lift stand. (
M6
6 Nm
(4.4 lbf ft)
M8
M6
M6
p. 43)
67
Loctite
®
243™
15 Nm
(11.1 lbf ft)
10 Nm
(7.4 lbf ft)
10 Nm
(7.4 lbf ft)