14
ELECTRICAL SYSTEM
14.1
Removing the battery
Warning
Risk of injury Batteries contain harmful substances.
–
Keep batteries out of the reach of children.
–
Keep sparks and open flames away from the batteries.
–
Only charge batteries in well-ventilated rooms.
–
Maintain a minimum clearance from inflammable materials when charging batteries.
Minimum clearance
–
Do not charge deeply discharged batteries if charge is already below the minimum voltage.
Minimum voltage before the start of the charge
–
Dispose of batteries with less than the minimum voltage correctly.
14.2
Installing the battery
(TX 300)
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the air filter box cover. (
–
Remove the seat. (
Main work
–
Pull back the negative terminal cover
the battery.
–
Pull back the positive terminal cover
the battery.
–
Remove screw
–
Pull holding bracket
H01190-10
(TX 300)
Main work
–
Position the battery in the battery compartment with the terminals facing forward,
and secure with holding bracket
Battery (HJTZ5S-FP) (
–
Mount and tighten screw
Guideline
Screw, battery support bracket
–
Connect positive cable
Guideline
Screw, battery terminal
Contact disks
with the claws toward the battery terminal.
–
Slide positive terminal cover
H00388-10
1 m (3 ft)
9 V
p. 55)
p. 53)
and disconnect negative cable
and disconnect positive cable
.
forward and take out the battery toward the top.
.
p. 123)
.
to the battery.
must be mounted under screws
over the positive terminal.
M6
10 Nm (7.4 lbf ft)
M5
2.5 Nm
(1.84 lbf ft)
and cable sockets
86
from
from