11
SERVICE WORK ON THE CHASSIS
11.20
Removing the seat
–
Mount the chain.
–
Connect the chain with the connecting link.
Guideline
The closed side of the chain joint lock must face in the direction of travel.
H01540-01
–
Position the foot brake cylinder.
Push rod
The dust boot is correctly positioned.
–
Mount and tighten screws
Guideline
Remaining screws, chassis
H01545-10
–
Position the angle lever and linkage lever.
–
Mount and tighten fitting
Guideline
Nut, linkage lever to angle lever
Info
Pay attention to flat area
–
Mount and tighten screw
H01546-10
Guideline
Screw, bottom shock
absorber
Info
Raise the wheel slightly to be able to mount the screw more easily.
–
Position the frame protectors on the left and right.
–
Mount and tighten screws
Guideline
Screw, frame protector
–
Mount and tighten screws
Guideline
Screw, frame protector
H01536-11
–
Mount the cable tie(s).
–
Check the free travel of the foot brake lever. (
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Remove the air filter box cover. (
engages in the foot brake cylinder.
.
.
.
.
M10
.
with the washers.
p. 55)
M6
10 Nm (7.4 lbf ft)
M14x1.5
80 Nm (59 lbf ft)
60 Nm
Loctite
(44.3 lbf ft)
M5
3 Nm (2.2 lbf ft)
M5
3 Nm (2.2 lbf ft)
p. 76)
p. 43)
53
®
2701™