Minolta CR-400 Instruction Manual page 70

5 Insert the edge of roll paper into the slot
as shown in the figure.
Inner surface of roll paper is up side.
Inserting the paper upside down results in
nothing printed.
Pull out the edge of the roll paper by 4-
6
5 cm manually.
Move the paper lock lever to CLOSE.
7
Do not pull out the roll paper after locking,
as this may cause a malfunction.
Lead the roll paper through the roll pa-
8
per cut holder and then set the roll pa-
per cut holder to the instrument in the
direction of the arrow.
9 Put the roll paper into the paper cham-
ber, and close the cover.
Do not print without the roll paper, as this
may cause a malfunction.
Notes on Use
• Do not place soluble adhesives, adhesive tape, etc. on the side of the paper to be printed on.
• Do not place in direct contact with plastic office supplies for long periods of time.
• Do not handle with wet or sweaty hands.
• Do not hit with hard objects.
• When writing titles, etc., use fountain pens, pencils, or water-based pens. Do not use oil-based pens.
68
Paper lock lever