Sip/Sop Connections; Changing To Pc Mode - Minolta CR-400 Instruction Manual

SIP/SOP Connections

• Accessories equipment connected the analog and digital interfaces must be certified to the respec-
tive IEC standards ( i.e. IEC950 for data processing equipment.)
• Furthermore all configurations shall comply with the system standard IEC 1010-1, Everybody who
connects additional equipment to the signal input part or signal output part configures a electrical
equipment for measurement system, and is therefore, responsible that the system complies with the
requirements of the system standard (IEC 1010-1. If in doubt, consult the technical services depart-
ment or your local representative.)
<Changing to PC Mode>
PC
[Operating Procedure]
1 Turn the power OFF ( O ) and connect the instrument to the PC using the RS-232C
cable.
Turn the power ON ( I ).
2
50
1 2
POWER
RS-232C cable
CR-A102
RS-232C terminal
4
3,5