Connecting The Measuring Head And Data Processor - Minolta CR-400 Instruction Manual

Connecting the Measuring Head and Data Processor

Precautions regarding connecting and disconnecting the measuring head and data processor.
• Before connecting and disconnecting, make sure that the power to both the measuring head and
dataprocessor is turned OFF.
• Hold the connector when connecting or disconnecting. Do not bend, pull, or apply undue pressure
to the cord, as this may cause it to break.
• When using the measuring head alone or replacing it, some items in the data processor settings may
be changed at the connection. See P.64 "Setting Status of Connected Measuring Head and Data
Processor" for details on the default values and status during connection of all settings shared by the
measuring head and data processor when connected.
• We recommend using the measuring head and the data processor with the same settings.
[Operating Procedure]
1 Make sure the power switches on the measuring head and data processor are
OFF (O).
Insert the one side of the RS-232C cable to the RS-232C terminal on the measur-
2
ing head.
3 Insert the other side of the RS-232C cable to the RS-232C terminal on the data
processor.
When removing the RS-232C cable, turn OFF
the measuring head and data processor and push
the lock release button certainly while removing
the cable.
If the lock is not released and remove it by force,
the connector may be damaged.
RS-232C terminal
RS-232C terminal
Lock release
button
63