Renishaw OTS Installation Manual page 42

OTS installation guide
Symptom
Machine stops
unexpectedly during
a probing cycle
6.2
Probe crashes
Optical communication
obstructed
Interface/receiver/machine fault
Dead batteries
False probe trigger
Probe unable to find target
surface
Adjacent probe
Tool length offset incorrect
Controller wired to respond to
inspection probe instead of tool
setter
www.armata-cnc.ru info@armata-cnc.ru
Cause
Check interface/receiver and
remove obstruction
Refer to interface/receiver/
machine User's guide
Change batteries
Enable enhanced trigger filter
Check that part is correctly
positioned and that stylus has
not broken
Reconfigure to low power mode
and reduce range of receiver
Review offsets
Review installation wiring
+7(495)797-78-97
Action