Mounting The Ots On A Machine Table - Renishaw OTS Installation Manual

Mounting the OTS on a machine table

1
2.5 mm AF
1.1 Nm
(0.81 lbf.ft)
1. Select a position for the OTS on the machine
table. Position to minimise the possibility of
collision and ensure the optical window faces
towards the receiver.
2. Separate the base from the body by
slackening four screws
using a 2.5 mm AF hexagon key.
3. Fit the cap head bolt and T nut (not supplied
by Renishaw) and tighten to secure the base
to the machine table.
NOTE:
A smaller washer may be fitted for a smaller bolt
by disassembling and separating the base plates.
www.armata-cnc.ru
Body
1
2
2.5 mm AF
1.1 Nm
(0.81 lbf.ft)
1 2
and two screws
info@armata-cnc.ru
M10/M12 bolt and T nut
(supplied by user)
Base
4. Refit the body onto the base and tighten
1 2
screws and . If a square stylus is fitted
and fine rotational adjustment is required, see
Stylus rotational setting pages 3.9 - 3.12,
before tightening screws
5. Fit the stylus. See Fitting the stylus, break
stem and captive link page 3.3.
Dowel pins (shown on page 2.5)
Two dowel pins (supplied in the tool kit) may
be fitted on installations where there is a
requirement to remove and remount the tool
setter.
To fit the dowel pins, drill two holes in the
machine table to correspond with the two probe
base holes. Place the dowel pins in the holes and
refit the probe base.
+7(495)797-78-97
1
2
1
2.
3.5