Setting From Sequence Program; Setting And Operation Using The Buffer Memory - Mitsubishi FX2N-16CCL-M User Manual

FX2N-16CCL-M CC-Link System Master Block
7.3

Setting from Sequence Program

This section explains the parameter setting within the sequence program.
Parameters can be set using the following two methods:
1) Setting and operation using the buffer memory (Refer to subsection 7.3.1)
Use this method when starting up the system or when giving a change or addition to the
system after operation.
2) Parameter registration procedure to the EEPROM and operation based on parameters
registered in the EEPROM (Refer to subsection 7.3.2)
Registering parameters in advance to the EEPROM can save the parameter setting
program, and reduce the startup time.
[Caution]
The auxiliary relays in the non-keep area must be used as auxiliary relays (M) for parameter
setting programs.For the details, refer to 9.1.
7.3.1

Setting and operation using the buffer memory

M8000
RUN monitor
M20
Module error
M0
M1
M1
Only when
required
M1
M35
Module ready
FROM K0 HA K4M20
PLS
SET
MOV
MOV
MOV
TO K0 H1 D0
MOV
TO K0 H6 D3
MOV
TO K0 H10 D4
M0V
TO K0 H14 D5
MOV
MOV
TO K0 H20 D13
RST
Parameter Setting 7
→M35 to M20
K1
BFM#A
H
M0
M1
Number of connected modules
D0
Number of retries
D1
D2
Number of automatic return
modules
K3
Operation specification against
D3
CPU down
K1
D4
Reserved station specification
K1
D5
Invalid station specification
K1
D13
Station information (set for
only connected modules)
D
K
M1
7-5