Mode Setting; Transmission Speed Setting; Condition Setting - Mitsubishi FX2N-16CCL-M User Manual

FX2N-16CCL-M CC-Link System Master Block
8.6.2

Mode setting

When executing the data link, the normal setting is "0(online)".
8.6.3

Transmission speed setting

The available transmission speed varies depending on the total extension distance.
For the details, refer to Section 4.4.1.
Set the same transmission speed to all of the master station and remote stations.
If the setting is different even in one station, normal data link cannot be realized.
8.6.4

Condition setting

The table below shows the setting method of the condition setting switch (DIP switch).
Table 8.4:
Number
SW1
SW2
SW3
Input data status of
SW4 data link faulty
station (Section 5.8)
SW5
SW6
SW7
SW8
Point
Switch status
Description
OFF
(Unusable)
(Unusable)
(Unusable)
Clear
(Unusable)
(Unusable)
(Unusable)
(Unusable)
ON
⎯
⎯
⎯
Sets to OFF all of the input data from data
OFF
link faulty station.
Keep
Keeps the input data from data link faulty
ON
station in the status just before error.
⎯
⎯
⎯
⎯
Data Link Procedure 8
Setting
Always OFF
Always OFF
Always OFF
Always OFF
Always OFF
Always OFF
Always OFF
8-14