Operator Panel; Status Led; Figure 1-2 Operator Panel; Table 1-1 Status Led On Operatorpanel - NEC T30A User Manual

1.3.2 Operator panel

The operator panel has LEDs that indicate the status of the library, an LCD panel that displays the
library status, operations, messages, library settings, error messages, etc., and buttons used to operate the
library.

1.3.2.1 Status LED

The following four LEDs are included in the operation panel.
Ready indicator
This Green LED is on when library is ready state to the host.
On :Ready
Blinking : Library being initialized or an inventory is being taken
:The accessor moves by the command from the host/WEB/operator panel
: Initialize the drive / Diagnosing / Magazine is opend / Library is offline state.
Drive cleaning indicator
Lighting:The drive is requesting cleaning.
Blinking:The drive is being cleaned.
Cartridge error indicator
Lighting：This Orange LED is on when the cartridge error has been detected.
When SCD=6/7/J is reported in cartridge Load to Drive.
When Cleaning cartridge is used 50 times or more.
Turning off method:Magazine opening and shutting
Attention:After it is opened and shut,this LED doesn't light even if the cartridge judged to be
abnormal before is turned on again in the magazine. (similar in case of I/O station)
Library error indicator
Lighting:This Orange LED in on when drive or accessor error has been detected.
Blinking:The library has recovered from error.
Turning off method:After the library has recovered(Blinking),please execute a warning off from

Figure 1-2 Operator panel

Table 1-1 Status LED on OperatorPanel

operator panel.(refer to 4.4.1)
-3-