NEC T30A User Manual page 241

Code( )
H
Command cannot execute in the recovery of
communication error
0m10h (FRU)
Drive n I/F cable, Drive n, CONTROLLER
BOARD
A timeout error occurred while waiting for
response from drive #n.Or The power supply is
not supplied to the drive.
0m11h
(FRU)
Drive n I/F cable, Drive n, CONTROLLER
BOARD
Detected time-out of the data transfer ready
reaponse with Drive-n.
0m12h (FRU)
Drive n I/F cable, Drive n, CONTROLLER
BOARD
ACK from drive n was not detected.)
(FRU)
0m13h
Drive n I/F cable, Drive n, CONTROLLER
BOARD
Drive #n failed to communicate because of being
pulled out.Or drive isn't installed.
0m14h (FRU)
Drive n I/F cable, Drive n, CONTROLLER
BOARD
The command to Drive n became a parameter
error.
0m15h
(FRU)
F/W, Drive F/W
Detected time-out of the data response with
Drive –n.
0m16h (FRU)
Drive n I/F cable, Drive n, CONTROLLER
BOARD
Command cannot execute in initialization of
Drive-n.
0m17h (FRU)
Drive n I/F cable, Drive n, CONTROLLER
BOARD
The command to Drive n terminated abnormally
by Sense Key and ASC/ASCQ code outside
0m18h assumption.
(FRU)
F/W, Drive F/W
The command transmission from Drive n to
Encryption Key Manager is retry-over.
0m19h (FRU)
LAN cable, Drive n I/F cable, CONTROLLER
BOARD
The command transmission from Encryption
Key Manager to Drive n is retry-over.Encryption
Key
0m1Ah
(FRU)
LAN cable, Drive n I/F cable, CONTROLLER
BOARD
The cleaning medium loaderd to Drive n reached
the endurance frequency (50 times).
0m1Bh
(FRU)
Cleaning Cartridge
Detected the media error with Drive n.
0m1Ch (FRU)
Cartridge
Detected the hardware error with Drive n.
0m1Dh
(FRU)
Drive error code (2/6)
Description
-214-
Panel
Indicator
CHK
0m10
CHK
0m11
CHK
0m12
CHK
0m13
CHK
0m14
CHK
0m15
CHK
0m16
CHK
0m17
CHK
0m18
CHK
0m19
CHK
0m1A
CHK
0m1B
CHK
0m1C
CHK
0m1D
Action