Chapter7 Installation Of Option; Install Of Drive; Install Of Power Module - NEC T30A User Manual

Chapter7 Installation of Option

Install the option after stopping JOB of the server when the option is increased, and
cutting the power supply in the library.
Reboot the server after completing an optional install. If the server is not rebooted, the
library cannot be normally recognized from the server.
When the power source module is increased in case of the case of T60A, it is not
necessary to stop the server JOB, and to cut the power supply in the library.

7.1 Install of drive

This section provides the procedure of installation drive.
1) Stop any jobs running on the server.
2) If there is a cartridge in the drive, move it to the magazine slot by using the backup software or
by using the operating panel.
3) Turn off the power to the library.
4) The drive module is installed, and the drive module is fixed with two screws.
When drive # 2 is increased, the escape slot is mounted. Please detach the escape slot referring
to "Exchange of 10.10 save in the clause slots", and install the drive module.
In the case of T60A, please install the drive module detaching the screw two places where the
drive cover is fixed when increasing it in drive # 3/#4.
Please abandon detached escape slot and drive cover.
5) Stick the name of product label attached to a drive in the label plate installed in the rack mount
kit back side.
6) Turn on the power to the library.
7) Perform drive diagnostics, referring to 9.2.
8) Connect the interface cable.In the case of FC drive,set topology / Loop ID / Link Speed /
Media Changer path.In case of SAS drive,set media changer path.
9) Confirm operation check after installation.Refer to 2.7.

7.2 Install of power module

This section provides the procedure of installation power module.
1) The cover of the power supply blank mounted on the position of a red square frame of the
figure below is detached. Detaching the blank cover draws out the power supply while pulling
the lock of a blue projection part forward.
2) The power source module is installed.
3) Insert the AC power cable in the connector of the AC power supply increased.
Please confirm the plug has been completely inserted.
4) Stick the name of product label attached to a power module in the label plate installed in the
rack mount kit back side.
-151-