Table of Contents
Advertisement
Installation and Connection of Disk Array Unit
•
Do not use the disk array unit in an area of high humidity or where water
usage occurs. If so, a fault, electrical shock, or fire may occur.
•
Do not use the disk array unit in an area where inflammable gas and/or
combustible materials are placed. If so, fire or explosion may occur.
•
Do not install the disk array unit in a dirty or dusty environment. Remove
any dust adhering to AC outlets and the plugs of power cords. If dust
remains adhering to an AC outlet and/or plug, fire may occur.
•
Do not overload AC outlets with power cords. If so, fire may occur.
•
Do not put heavy materials on a power cord. If so, the insulating coating of
the power cord may be broken, fire may occur, and/or you may be
electrically shocked.
•
Do not connect the plug of a power cord to an AC outlet or distribution
board with a wet hand. If so, you may be electrically shocked.
•
Make sure to disconnect all power cords and cables before relocating the
disk array unit. If not, a malfunction of the system, an electric shock and/or
fire may occur.
•
While the disk array unit can accept power in the range of 100 - 240 VAC
(50/60 Hz), the power cord shipped with the disk array unit can only accept
100 – 120 VAC. Use 100 – 120 VAC (50/60 Hz) when the enclosed power
cord is used. Using power of different voltage may cause electric shock,
smoke, and/or fire to occur.
•
Do not install the disk array unit and the power cords in an area with direct
sunshine or near any apparatus generating heat such as a heater. If so, a
fault may occur. Further, the insulating coating of the power cord may be
damaged causing fire or electric shock to occur.
•
The disk array unit weighs 34 kg or more. Hold the disk array unit or disk
enclosure firmly using at least three people to carry it. Carrying the devices
by two or less people may cause personal injury.
•
Select a location where the disk array unit can be connected to the AC
outlet or distribution board by using the attached power cord, without using
an extension cord,
•
Insert the plug of a power cord into an AC outlet securely. If some clearance
remains between the plug of the power cord and the AC outlet, dust may
enter into the clearance. This then may cause fire to occur.
•
Provide sufficient margins for the cables connected to the disk array unit so
that entanglement is not an issue. Avoid placing unnecessary strain on
power plugs and FC connectors.
•
Do not crimp cables connected to the disk array unit. If so, a fault or fire
may occur.
WARNING
CAUTION
xxi
Advertisement
Table of Contents
