Drive Motor; Remove; Install - Taylor-Dunn SC-011-59 Operation, T Roubleshooting And Replacement Parts Manual

Transmission

DRIVE MOTOR

Remove

NOTE: In most cases it is not necessary to disassemble the chain case to
6. Remove the four motor wires.
7. Loosen the drive chain adjusting screw.
8. Remove the hardware holding the motor to the chain case backing plate.
9. Lift the rear of the motor and rotate the motor so that the motor mounting plate clears the two
threaded studs on the chain case backing plate and remove the motor from the drive.

Install

1. Tie the chain up in position with mechanics wire as
shown.
2. Slip the motor sprocket under the chain and rotate
the motor so that the mounting plate goes into the
threaded studs and remove wire(s) holding the
chain.
3. Install the motor mounting hardware but do not
tighten until the chain adjustment is complete.
4. Adjust the drive chain. Refer to
Chain
for information regarding adjusting the drive
chain.
5. Connect the motor wires.
6. Reconnect the main positive and negative at the
batteries, remove the blocks from the wheels, and
test drive.
remove the motor. If you find it necessary to disassemble the chain
case, refer to Transmission section for information regarding
disassembly of the chain case.
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Do not allow the wheels to rotate after the motor has been removed.
Allowing the wheels to rotate may result in the drive chain getting bound
up with the drive sprocket, locking up the transmission. Should this
happen, the chain may have to be disassembled to free up the chain.
Adjust the Drive
Transmission Page 6