Charging Time; Storing And Returning To Service; Storing Your Vehicle; Returning To Service - Taylor-Dunn SC-011-59 Operation, T Roubleshooting And Replacement Parts Manual

Table of Contents

Advertisement

SAFETY RULES AND OPERATING INSTRUCTIONS

Charging Time

Average charging time is 8 to 10-hours. The time required
to fully charge your batteries will vary depending on:
Capacity of the batteries, higher capacity requires
longer charge time.
Output of the charger, higher output requires less
charge time.
Depth of discharge, the deeper a battery is
discharged, the longer it takes to charge.
Temperature, low temperatures require longer charge
time.
It is not unusual for charge times to exceed 15-hours,
especially with new batteries.
To obtain the maximum battery life:
Charge the batteries only after they reach a normal
discharge as indicated on the Battery Status Indicator
(BSI). Failure to follow this guideline could result in the
batteries entering an overcharge state, which will reduce
the life of the batteries. If you find it necessary to charge
the batteries before they are completely discharged we
recommend waiting until they are discharged a minimum
of 25% to reduce the possibility of overcharging. Refer
to Vehicle Controls in this section for information on how
to read the BSI.
Do not discharge the batteries beyond a normal
discharge as indicated on the BSI. Refer to Vehicle
Controls in this section for information on how to read
the BSI.
Check the battery electrolyte once a week. Do not charge
the batteries if the battery electrolyte is low. Charging
when the electrolyte is low will damage the batteries and
shorten their life-span. Only authorized personnel should
perform battery maintenance including maintaining the
battery electrolyte level. Refer to Section
Service and Repair
information.
Do not interrupt the charging cycle. When the charger is
plugged in, allow it to turn off before disconnecting.
Interrupting the charging cycle could lead to overcharging
or discharging the batteries too deep. Both circumstances
will shorten the life of the batteries.
Maintenance,
for battery maintenance
STORING AND RETURNING TO
SERVICE
Both storing your vehicle and returning it to service
should only be performed by authorized personnel.

Storing Your Vehicle

Clean the batteries, then fill and charge before
putting the vehicle in storage. Do not store batteries
in a discharged condition.
Lube all grease fittings.
Clean, dry, and check all exposed electrical
connections.
Inflate tires to proper pressure (if applicable).
For extended storage, the vehicle should be elevated
so that the tires do not touch the ground.
If stored for a prolonged period, the batteries should be
charged as follows:

Returning to Service

Storage
Temperature
(F)
Over 60
Between 40 and 60
Below 40
Check the battery's state of charge and charge if
required.
Perform ALL maintenance checks in the periodic
checklist.
Remove any blocks from the vehicle and/or place
the vehicle down on to the ground.
Test drive before putting into normal service.
Charging Interval
(months)
1
2
6
Safety Rules
Page 11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sc 159An-011-71An 171

Table of Contents