Change The Oil - Taylor-Dunn SC-011-59 Operation, T Roubleshooting And Replacement Parts Manual

CHANGE THE OIL

6. Place a large drain pan under the chain housing.
7. Remove the chain case drain plug and allow all of
the oil to drain from the housing and then reinstall
the drain plug
8. Place the drain pan under the drive housing.
9. Remove the drive housing drain plug and allow all
of the oil to drain from the housing and then reinstall
the drain plug
10. Remove the chain case fill plug and add 1-pint of
oil.
11. Remove the drive housing fill plug and add 2-quarts
of oil.
NOTE: Refer to the Lubrication Chart for
12. Replace all fill plugs.
NOTE: Dispose of waste oil in accordance with your local regulations.
13. Reconnect the main positive and negative at the batteries, remove the blocks from the wheels,
and test drive.
Wear protective gloves when working with petroleum lubricants.
Repeated contact with petroleum lubricants can result in skin
disorders.
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
information regarding the type of oil.
Transmission
Typical location of oil plugs. The actual location
of the plugs will vary depending on your
vehicles configuration.
R
Page 5
Transmission