Taylor-Dunn SC-011-59 Operation, T Roubleshooting And Replacement Parts Manual page 77

10. If required, remove the rear tapered bearing from the pinion shaft and discard.
NOTE: Do not remove the bearing unless it requires replacement.
Removing the rear bearing will damage the bearing. Replacing this
bearing will require re-shimming of the pinion shaft.
11. If required, remove the bearing races from the pinion housing.
12. Mark the differential bearing caps and 3rd member housing so that they can be reassembled in
their original location. Refer to illustration at end of section.
NOTE: The caps cannot be interchanged or replaced. If the caps are lost
or damaged then the entire 3rd member assembly must be replaced.
13. Remove the differential bearing caps, bearing adjusting nuts and races.
14. Remove the differential assembly from the 3rd member.
15. Mark the ring gear and differential housing so that the ring gear can be reinstalled in the same
orientation.
16. Remove the bearings from the differential housing and discard.
NOTE: Removing the bearings will damage the bearings. Do not remove
the bearings unless they require replacement.
17. Remove the ring gear from the differential housing.
18. Remove the differential shaft locking roll pin.
19. Split the 2-piece differential housing.
20. Drive the differential pinion shaft out of the housing
with a brass drift punch.
21. Remove the differential gears, axle gears, and
thrust washers.
R
Transmission Page 15
Transmission