Chain Case; Disassemble; Assemble - Taylor-Dunn C0-014-32 Operation, T Roubleshooting And Replacement Parts Manual

CHAIN CASE

NOTE: Some vehicle configurations may require that
the transmission be removed to disassemble
the chain case.
Transmission Assembly
on removing the transmission.

Disassemble

1. Make sure the key-switch is in the "OFF"
position, then remove the key.
2. Place the forward-reverse switch in the
center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to
prevent vehicle movement.
5. Disconnect the main positive and
negative cables at the batteries.
6. Place an oil drain pan under the chain case.
7. Remove the chain case drain plug and allow all of
the oil to drain from the housing and then reinstall
the drain plug
8. Remove the brake drum. Refer to section
Brakes: Replace the Brake Drum
information regarding removing the brake drum.
9. Remove the nuts from the three threaded studs at
the small end of the chain case housing.
10. Remove the chain case housing bolts, brake
assembly, and alignment brackets.
11. Remove the chain case housing from the backing
plate.
12. Remove the pinion seal from the chain case
housing.
13. Loosen the motor mounting bolts.
14. Loosen the chain adjuster.
15. Remove the drive chain, motor nut and sprocket
and the drive sprocket.
16. If the backing plate must be removed from the
3rd member, first remove the motor from the
backing plate then remove the backing plate from
the 3rd member.
Maintenance, Service, and Repair
Refer to section
for information
for
Typical Chain Case

Assemble

1. Thoroughly clean all gasket surfaces.
2. Apply a 1/8" bead of 94-430-03 gasket sealer to
the face of the 3rd member.
3. Install the backing plate to the 3rd member. Torque
to 30-45 ft-lbs.
4. Install the motor to the backing plate. Do not fully
tighten the motor mounting hardware at this time.
5. Install the motor sprocket, drive sprocket and
chain. Do not adjust the chain tension at this time.
6. Apply a 1/8" bead of 94-430-03 gasket sealer to
the chain case housing.
Apply sealer around the ID of the holes
7. Install the chain case centering tool (refer to
Appendix A) into the pinion seal bore in the chain
case housing.
F2/F3 Transmission
Page 7