Advertisement
5.1.4
Setup mode
Operator can set following items by Setup mode.
No
Item
1
Double feed
check
2
IPC pre-setting
3
Reset of
Abrasion counter
4
Pick start time
setting
4
Time-out limit
setting
5
ADF front offset
setting *
6
ADF back offset
setting *
7
FB offset setting
*
8
IPC/Memory
status display
9
SCSI ID setting
* This offset means the deference from the value adjusted by automatic offset adjustment.
The procedures for setting Setup mode are as follows.
(1)
Turn the power ON by pressing "I" side of the power switch (see Figure 1.1). Then the
scanner displays "Scanner Ready"
Scanner Ready
Table 5.3 Functions of Setup mode
Description
Double feed is detected by checking
the document length one by one.
Scanner automatically sets the
recommended reading parameters.
Five recommended document
parameters are available.
Abrasion counter can be reset.
The time from the document
insertion to the start of picking is
specified. User can select most
comfortable Pick start time for the
job.
The time that the scanner waits for
next document insertion after last
document scanned can be specified.
Horizontal and vertical offset of the
front side image by ADF is
specified.
Horizontal and vertical offset of the
back side image by ADF is
specified.
Horizontal and vertical offset of the
FB image is specified.
The type of IPC option (IPC-2D or
IPC-3D) and total memory installed
are displayed.
SCSI ID is selectable
>
5.1 Operator panel operation
Selectable
Default
parameters
Tolerance:
No
No/10/15/20
mm
Document:
No
No/1/2/3/4/5
-
-
Time:
0.2 to 9.8 sec
1.0 sec
Time:
27 values from
30 sec
1 to 1999 sec
Offset:
Offset:
H: -2 to +3mm
H: 0 mm
V: -2 to +3mm
V: 0 mm
Offset:
Offset:
H: -2 to +3mm
H: 0 mm
V: -2 to +3mm
V: 0 mm
Offset:
Offset:
H: -2 to +3mm
H: 0 mm
V: -2 to +3mm
V: 0 mm
SCSI ID:
0/1/2/3/4/5/6/7
5
5-5
Advertisement
