Advertisement
Chapter 5 Operation and Maintenance
5.1
Operator panel operation
5.1.1
Operator panel function
Operator pane has one LCD, six buttons and three LEDs as follows. The functions of each button
and LED are shown in Table 5.1.
Scanner Ready
Name of the button
and LED
Next
Previous
ç
è
Button
Exit
ENTER
Power
READ
LED
Check
Counter
Paper counter
Abrasion counter
Paper counter
50
100000
Abrasion counter
Table 5.1 Functions of buttons and LEDs
LCD displays the next screen on the screen flow chart of Figure
5.1 or 5.2. The settings you have made is effective.
LCD displays the backward screen of the screen flow chart of
Figure 5.1 or 5.2. The settings you have made is effective.
Moves the cursor (the blinking part) to the left
Moves the cursor (the blinking part) to the right
• When "Check" LED lights, pressing this button releases error
status (turn off "Check" and returns to "Scanner Ready" screen).
• When you are setting on the operator, pressing this button
returns to "Scanner Ready" screen immediately. Note that the
setting you have select is effective after pressing this button.
Registers the parameter selected by cursor.
Indicates that the scanner is ON.
Indicates that the scanner is reading documents.
• If it blinks at one second cycle, it means that some temporary
error occurs. (See section 6.1)
• If it blinks at four seconds cycle, ADF cleaning is required.
• If it lights, it means that some alarm occurred. (See section 6.1)
Table 5.2 Functions of the counter
Paper counter counts the scanned sheet from the start of reading to
Hopper empty or an error detection.
Abrasion counter counts the accumulated number of the scanned
sheet. This counter increments at every 10 sheets. Use this counter to
check the cleaning cycle or parts replacement cycle.,
(↑)
(↓)
Previous
Next
ç
è
Function
Function
(STOP)
Exit
0 Power
0 READ
(START)
Enter
0 Check
5-1
Advertisement
