Advertisement
Operation and Maintenance
5.1.3
Manual Feed mode
In this mode, the scanner waits for some predetermined time without issuing "Hopper empty" after
all documents are read. This predetermined time (time-out limit) is specified by Setup mode.
Therefore you can set next documents on ADF chute without interrupting reading operation. The
procedures for setting manual feed mode are as follows.
(1)
Turn the power ON by pressing "I" side of the power switch (see Figure 1.1). The scanner
displays "Scanner Ready".
Scanner Ready
(2)
Press "Next" button. Then the scanner displays "Mode select 0"
Mode select 0
Reading mode change?
(3)
Press "Next" button. Then the scanner displays "Mode select 1"
Mode select 1
M Manual mode change?
(4)
Then press "Enter" button. Then the scanner displays following screen.
M01 Manual feed
= No/Yes
(5)
Select "Yes" by pressing "è" button, and press "Enter". Now the Manual Feed mode is set.
(6)
Press "Exit" to return to "Scanner Ready " screen.
Note that "Manual Feed" is shown on the. This means that the scanner is in Manual Feed
mode.
Manual Feed
Scanner Ready
5-4
Advertisement
