Advertisement
Operation and Maintenance
5.1.2
Feed Mode setting
The procedures for setting feed mode are as follows.
(1)
Turn the power ON by pressing "I" side of the power switch.
(2)
When the scanner displays "Scanner Ready", press "Next" button.
Scanner Ready
(3)
The scanner displays "Mode select 0" at the upper line of LCD, then press "Enter" button.
Now Feed Mode setting is ready.
Reading mode change?
(4)
Select the item by pressing "Previous" or "Back" button, and select the parameter by
pressing "ç" or "è" button, and press "Enter" button to set the parameter. Finally close
the Feed Mode setting by pressing "Exit" button. The flow chart of the Feed Mode setting is
shown In Figure 5.2.
M1
Scanner Ready xxxx
M2
Mode select 0
Reading mode Change?
M3
Mode select 1
M Manual mode Change?
M4
Mode select 2
Setup mode Change?
5-2
Mode select 0
xxx
Next
Previous
Previous
Next
Previous
Next
Figure 5.1 Mode change
M1 At Manual Feed mode
Exit
Manual Feed xxx
Scanner Ready xxxx
Enter
To Reading mode
Enter
To Manual Feed mode
Enter
To Setup mode
Advertisement
